(Your schematic appears perfect, outside any indication that the N-way splitter's ports are all connected or its unused ports capped w/ 75-ohm terminators. It might also be informative to post the MoCA stats from either the BOLT or one of the Mini's to see if the diagnostics indicate MoCA issues. Indicating no MoCA connection for your main MoCA/Ethernet bridge, this would preclude any network connection for your Mini's, so there just being a search issue is mysterious.Įdit: p.s. These allow you to run data over your existing home coax network without interfering with the cable. (Your schematic appears perfect, outside any indication that the N-way splitter's ports are all connected or its unused ports capped w/ 75-ohm terminators.) Installed and tested Motorolla MM1000 MoCA 2.0 adapters. Separately, how far is the BOLT from the router? Could it be connected via Ethernet to a LAN port on the router and configured as the MoCA bridge (with the MM1000 removed from the setup, if only temporarily)?Įdit: p.s. After that, order another MoCA adapter via Amazon or borrow one from a friend to test whether the MM1000 is faulty. and whether the BOLT can get an IP address and Internet connection. at the short-term expense of new recordings and Mini viewing, you could direct-connect the BOLT and MM1000 "Net" port via a short coax cable, and see how the MM1000's status LED responds. If you have done this correctly the Coax light will light up.Click to expand.Indicating no MoCA connection for your main MoCA/Ethernet bridge, this would preclude any network connection for your Mini's, so there just being a search issue is mysterious.
0 Comments
Leave a Reply. |